Synology DS1812 + 8x 2TB Guía de instalación descargar pdf (Pagina 11)

11 Chapter 2: Hardware Setup

3 Check Total Physical Memory in Main Menu > System Information.

If your DiskStation does not recognize the memory or does not start up successfully, confirm that the memory is

installed correctly.

To remove the RAM Module:

1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your DiskStation, disconnect the

cables, and then remove the top case.

2 Push the levers on the sides of the memory module in an outward direction to release the module from the

memory card slot.

3 Hold the memory module by its notches and remove it from the slot.

4 Replace the top case. Replace and tighten the screws you removed in step 2.

5 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on your

DiskStation.

Replace System Fan

Your DiskStation will play beep sounds if either of the system fans is not working. Follow the steps below to

replace the malfunctioning fan with a good one.

To replace the system fan:

1 Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possible

damages.

DS1812+

3072 MB

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Sin comentarios

Synology DS1812 + 8x 2TB Guía de instalación Pagina 11