Synology DS2415+ Guía de instalación descargar pdf (Pagina 12)

Chapter 2: Hardware Setup

To make sure DiskStation recognizes the new memory capacity:

Install DiskStation Manager (DSM). (See the next chapter for more information.)

admin

or a user belonging to the

administrators

group.

Check

Total Physical Memory

Control Panel

Info Center

IfyourDiskStationfailstoeitherrecognizethememoryorstartupsuccessfully,conrmthatthememoryhas

been properly installed.

To remove the RAM Module:

Follow step 1 and 2 of the “To install the RAM module” section to shut down your DiskStation, disconnect the

cables, and then remove the side cover.

Push the levers on the sides of the memory module in an outward direction to release the module from the

memory card slot.

Hold the memory module by its notches and remove it from the slot.

Replace the side cover. Replace and tighten the screws you removed in the initial step.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Sin comentarios

Synology DS2415+ Guía de instalación Pagina 12