Synology USB STATION 2 Guía de usuario Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
USB Station 2 User's Guide
Based on DSM 3.1
21 Chapter 3: Modify System Settings
Network Interface
In this section, you can connect your USB Station 2 to the network via any of the following network interfaces.
LAN
If your USB Station 2 is connected to a local area network, you can click LAN on the left side to configure the
network interface.
To decide how your USB Station 2 obtains IP address:
1 Choose either of the following:
Get network configuration automatically (DHCP): Get IP address automatically via DHCP.
Use manual configuration: Manually enter the IP address, subnet mask, DNS, and gateway.
2 Click OK.
To set up IPv6:
Click IPv6 Setup. See "IPv6 Setup" on Page 23 for more information.
Term Explanation
Jumbo Frames: Jumbo Frames are Ethernet frames with more than the standard 1500 bytes of Maximum
Transmission Unit (MTU), allowing Ethernet transmission of large files to be more efficient. It can only be
enabled under Gigabit network environment. To ensure Jumbo Frame works properly, all the computers and
devices across the network accessing your USB Station 2 must support it and use the same MTU value.
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 125 126

Comentarios a estos manuales

Sin comentarios