Synology RS2414+ Guía de instalación descargar pdf (Pagina 10)

10 Chapter 2: Hardware Setup

b Remove the two screws located on the back of your RackStation. Then slide the top cover in the direction

indicated below and lift.

Important: Removing the cover will expose sensitive internal components to possible harm. Please avoid touching

any other components when adding or removing memory.

4 To insert the new memory module, follow the steps below:

a Align the notch on the gold edge of the module with the notch in the memory slot.

b Use two fingers to apply firm, even pressure and push the memory module downward.

c When the memory is inserted correctly, the ejectors will snap into place.

5 Replace the top cover, slide it into place, and tighten the two screws on the back of your RackStation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Sin comentarios

Synology RS2414+ Guía de instalación Pagina 10