Synology RS814 Guía de usuario Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 115
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
Synology NAS User's Guide
Based on DSM 4.3
17 Chapter 3: Modify System Settings
Wireless
1
Click Wireless on the left side to connect the Synology NAS to a wireless network. Wireless network is available
only when a wireless dongle is plugged into the USB port of your Synology NAS.
IPv6 Setup
When you are configuring the LAN or Wireless Network interface, click the IPv6 Setup button to change the
IPv6 settings.
Synology NAS supports IPv4/IPv6 dual stack scheme. This means that both IPv4 and IPv6 can work
simultaneously on Synology NAS. The default setting for IPv6 is Auto.
2
PPPoE
Click the PPPoE on the left side if your Synology NAS is connecting to a DSL or cable modem, and your Internet
Service Provider (ISP) uses PPPoE (Point to Point Protocol over Ethernet).
Hotspot
3
For certain models, or if a wireless dongle
4
Tunnel
is connected to the USB port of your Synology NAS, you can enable
hotspot on your Synology NAS to turn it into a wireless access point that can share its wireless connection with
computers or mobile devices within the range of the Wi-Fi network.
Tunnel is a technique that encapsulates IPv6 packets within IPv4 packets, allowing isolated IPv6 host or network
to be compatible with IPv4 network backbone.
Click the Tunnel tab to allow your Synology NAS to gain Internet access via IPv6 under the IPv4 environment.
---------
1
Wireless network is supported on specific models only.
2
IPv6 service is only supported on 08-series models or later (excluding 108j, 109j).
3
Hotspot is supported on specific models only.
4
For a complete list of supported wireless dongles, visit www.synology.com.
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 114 115

Comentarios a estos manuales

Sin comentarios